Bootloader menu

[Janka]

BOOTLOADER MENU


The Bootloader is a program installed in STB to configure the STB boot process, make recovery STB operations, and for other auxiliary purposes. A Bootloader menu can be brought up during the STB boot process.

It is not recommended to make changes to the Bootloader menu without properly understanding Bootloader settings and the consequences of changing them!

How to bring up Bootloader menu

• Power off STB or use software reset (command Reboot device in System Settings);
• Press and hold down the Menu key on the Remote Control;
  
  Menu button on remote control
• Keep pressing the Menu key, power on STB (skip this item in case of software reset);
• Release Menu when Bootloader menu (blue screen) is loaded.

If there is no image on the screen may be your analog TV receiver doesn't support Video mode (PAL or NTSC) set on STB. Then complete the next steps:
Power off the STB;
Press and hold Menu on the RC (direct your RC right to the STB);
Power on the STB with holding Menu on the RC;
Keep on holding Menu during 5-10 seconds;
Switch PAL - NTSC with a single press on red (F1) key on RC.

Setting video output mode and graphic resolution


To correctly display the video signal on TV it is possible to change the following parameters at the boot stage:

• TV System - STB video output mode;
• Grafic Res. - resolution of STB video output window.

For description of these parameters, see "Video Output Mode and Graphic Resolution".